Learn the Material
The whole pool in publication order, answers marked. Nothing here is scored and nothing changes your study statistics.
Notice: You have access to 14 of 64 questions in this course. You can subscribe later for only $10/mo. to unlock the entire course.
A1 — Air Brake System Parts and Terms
17 questions · 7 on the exam · 13 held back
Watch
A1 — Air Brake System Parts and Terms
Practice
A: Air Brake System Parts and Terms · 17 questions
What is an air brake system?
- AA system that uses air as a medium for transmitting pressure or force from the driver control to the service brake
- BA system that uses air only to assist the driver's leg force on hydraulic brakes
- CA system that cools the brakes with air
- DA system that uses an electric current
Why
393.5 defines an air brake system.
What is an air-over-hydraulic brake subsystem?
- AA hydraulic system with no air
- BA subsystem that uses compressed air to transmit a force from the driver control to a hydraulic brake system
- CAn air system with no driver control
- DA parking brake cable
Why
393.5.
What is a service brake system?
- AA brake that holds a parked vehicle
- BA brake used only after a failure
- CA primary brake system used for slowing and stopping a vehicle
- DA brake on the trailer only
Why
393.5.
What is a parking brake system?
- AThe primary brake for slowing
- BA brake used only on hills while moving
- CThe engine brake
- DA mechanism designed to prevent the movement of a stationary motor vehicle
Why
393.5.
13 more questions in this group are in the full course.
Unlock the Full Question Bank
Start a 2-day free trial to study every question and take full practice tests. Then $10/month for this course. Cancel anytime in your account. One free trial per person.
A2 — Required Equipment and Warning Devices
28 questions · 11 on the exam · 22 held back
Watch
A2 — Required Equipment and Warning Devices
Practice
A: Required Equipment and Warning Devices · 28 questions
What must a vehicle with air brakes have to show the driver the air available for braking?
- AOnly a warning light
- BA pressure gauge and a warning signal
- COnly a buzzer
- DNo gauge is required
Why
393.51(c).
Where must the air pressure gauge be visible?
- AFrom outside the cab
- BOnly from the sleeper berth
- CTo a person seated in the normal driving position
- DUnder the hood
Why
393.51(c)(1).
At what air pressure must the low air warning signal (on vehicles not built to FMVSS 121) warn the driver?
- AAt 100 psi
- BAt 90 psi
- CAt 20 psi
- DAt 55 psi (379 kPa) and below, or one-half of the governor cutout pressure, whichever is less
Why
393.51(c)(2).
What kind of warning must the low air pressure signal give?
- AA continuous warning, audible or visible to the driver
- BA single short beep
- CA warning only when the engine starts
- DA light outside the vehicle
Why
393.51(c)(2).
When must a bus, truck or truck tractor warn the driver about the service brake system?
- AOnly during inspections
- BWhen a failure occurs in the vehicle's service brake system
- COnly at night
- DNever
Why
393.51(a).
For air-braked vehicles not built to FMVSS 121, a full brake application with the engine stopped may not drop the air pressure below what?
- A50 percent
- B90 percent
- C70 percent of the gauge reading just before the application
- D20 psi
Why
393.50(b).
22 more questions in this group are in the full course.
Unlock the Full Question Bank
Start a 2-day free trial to study every question and take full practice tests. Then $10/month for this course. Cancel anytime in your account. One free trial per person.
A3 — Inspection, Adjustment and Performance
19 questions · 7 on the exam · 15 held back
Watch
Inspection, Adjustment and Performance
Practice
A: Inspection, Adjustment and Performance · 19 questions
What must be true of the service brake chambers on each end of an axle?
- AThe left one must be larger
- BThey must be the same size
- CThey may be any size
- DOnly one is required
Why
393.47(b).
What must be true of the slack adjusters on each end of an axle?
- AThey must point in opposite directions
- BOne must be longer
- CTheir effective length must be the same
- DOnly one is required
Why
393.47(c).
What is the minimum brake lining thickness on a non-steering axle air drum brake?
- A1.6 mm (1/16 inch)
- B12 mm (1/2 inch)
- CThere is no minimum
- D6.4 mm (1/4 inch), or to the wear indicator
Why
393.47(d)(2).
For an actuator type not listed in the tables, with a rated-stroke marking and no manufacturer readjustment-limit marking, what is the maximum pushrod stroke?
- ANot greater than 80 percent of the rated stroke marked on the actuator
- B100 percent of rated stroke
- C50 percent of rated stroke
- DThere is no limit
Why
393.47(e)(2).
15 more questions in this group are in the full course.
Unlock the Full Question Bank
Start a 2-day free trial to study every question and take full practice tests. Then $10/month for this course. Cancel anytime in your account. One free trial per person.
End of the free questions
You Have Read All 14 Free Questions
The other 50 are in the full course, with Study mode and the full practice test on every one of them. Month to month: cancel any time, and you keep access until the end of the month you paid for.